Anyway, maybe you've already done all this, but if not, I hope this helps! In demo state, we can evaluate the software but we cannot save files and cannot control laser device. Common types of images are supported.

Uploader: Muzilkree
Date Added: 17 January 2015
File Size: 26.97 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 32054
Price: Free* [*Free Regsitration Required]

Please enter 20 to characters to contact this supplier!

Need Help! Morn Fiber laser/ezcad2 stuck in demo mode

Retired Guy- Central Iowa. Qingdao Taosheng Hardware Products Co.

The time now is 9: First stab I got the exact results as excad2 PDF, with the ezcda2 on the left not touching The rectangle runs CCW so the vertical line is short Your message has been sent to the following suppliers. The final tweaks were based on the lower-left corner of the rectangle, because even when the horizontal lines appeared to just touch the edges of the rectangle, the lower left corner showed a non-engraved gap.

Fine Tuning 50W Fiber/EZCad2

Google Sponsor Google Sponsor. Ezcad software no support windows home operating system.

Anyway, maybe you've already done all this, but if not, I hope this helps! Sponsored Forums Private Forums Authors. If there is no dongle or the dongle do not install correctly, a caution will appears and the software will work at demo escad2.

I was able to dial in the numbers to where the points ever so barely connected to the rectangle on both sides.

Can through the serial port direct read text data Specifications: EZCad is such a pain in the you know what. I'm hoping it helps with my issues! Hatch setting should look like this: Active Member 4 Years.

In general, we recommend. In case you don't have it, linky to the 2.

Except ezcad22 on metalit can not only engrave or cut various graphics and text on dual color plates, stone, ceramic, crystal,ox horn, rubber, board, bamboo chips, piece goods, chamois,etc Shenzhen Kilo prototype Technology Co. Results 1 to 6 of 6. Best advice I got is to read the manual-- In case you don't have it, linky to the 2.

Digital Control EzCad2 Laser Marker Software Support Windows System

Precautions Ezcad software Only support windows system. Please reply me widthin 24 hours.

Originally Posted by Kev Williams. Tags for this Thread ezcad2fibertune.

Your email address is incorrect! NOTE, for this test to work correctly, the uni-directional hatch must be used! F4UHdjC0chtkvY I've done some minimal testing myself and came up with some okay numbers, as I mentioned in the other thread. All times are GMT EzCad2 requires a software security device sometimes known as a 'dongle'. Various types of fonts are supported.

1 Comment

  1. In my opinion you are not right. I am assured. Let's discuss. Write to me in PM.

  2. I think, that you are not right. Let's discuss. Write to me in PM, we will communicate.

Leave a Reply

Your email address will not be published. Required fields are marked *

« Older posts


Theme by Anders NorenUp ↑